Printing Using the Computer
76
4
Connecting Using USB 4
a Before connecting the USB cable, make sure that the P-touch is turned off.
b Connect the P-touch end of the USB cable to the USB port on the back of the P-touch.
c Connect the other end of the USB cable to the USB port on the computer.
d Turn the P-touch on.
Connecting Using Wi-Fi 4
You can select the network type, configure or display the network settings using [Settings] in the Home
screen. You can also use [Communication settings] in the Printer Setting Tool for detailed configuration.
For more information see Changing the P-touch Settings on page 94.
The following Wi-Fi connection methods are available:
Infrastructure Mode
Ad-Hoc Mode (To set the Ad-Hoc mode, use the Printer Setting Tool (see Changing the P-touch Settings
on page 94).)
Infrastructure Mode 4
Infrastructure mode allows you to connect the P-touch to a computer via a wireless access point/router.
Before You Begin
First you must configure the Wi-Fi settings of your P-touch to communicate with your wireless access
point/router. After the P-touch has been configured, computers on your network will have access to the
P-touch.
• If you are going to connect the P-touch to your network, we recommend contacting your system
administrator prior to installation. You must confirm your Wi-Fi settings before you proceed with this
installation.
• To configure the Wi-Fi settings again, or if the status of the Wi-Fi connection for your P-touch is not clear,
reset the Wi-Fi settings of the P-touch.
1 Select [Settings] in the Home screen using the , , or key, and then press the OK or Enter
key.
2 Select [Reset] using the or key, and then press the OK or Enter key.
3 Select [Reset Wi-Fi Settings] using the or key, and then press the OK or Enter key.
To Next Page
Loading...
