EasyManua.ls Logo

Brother E850TKW - Removing the Rechargeable Li-Ion Battery; Charging the Rechargeable Li-Ion Battery

Brother E850TKW
255 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using the Rechargeable Li-ion Battery/Battery Base (Optional: PA-BT-4000LI/PA-BB-003)
195
21
Removing the Rechargeable Li-ion Battery 21
Press and hold the (Power) button to turn the P-touch off.
Remove the battery cover and the battery, and then reattach the battery cover.
CAUTION
If it is difficult to remove the rechargeable battery, turning the P-touch over with the battery cover removed
may allow the rechargeable battery to fall out.
Be careful that this does not cause any injuries.
Charging the Rechargeable Li-ion Battery 21
Note
Before use, fully charge the battery.
Up to three hours may be needed to fully charge the battery.
a Make sure the battery is installed in the P-touch.
b Use the AC adapter and power supply cord to connect the P-touch to an electrical socket.
Press the (Power) button to turn the P-touch on if it is not on already.
The (Battery) indicator lights in orange during charging, and it goes off when the battery is fully
charged.
1 AC adapter
2 Power supply cord
Note
Even if the P-touch is turned off during charging, the charging will continue until the battery is fully charged.
1
2

Table of Contents