Troubleshooting and routine maintenance
C - 19
C
Setting Dial Tone detection
When you send a fax automatically, by
default your machine will wait for a fixed
amount of time before it starts to dial the
number. By changing the Dial Tone setting to
Detection you can make your machine dial
as soon as it detects a dial tone. This setting
can save a small amount of time when
sending a fax to many different numbers. If
you change the setting and start having
problems with dialling you should change
back to the default
No Detection setting.
1
Press Menu/Set, 0, 5.
2
Press ▲ or ▼ to select Detection or
No Detection.
Press Menu/Set.
3
Press Stop/Exit.
Compatibility
If you are having difficulty sending or
receiving a fax due to possible interference
on the phone line, we recommend that you
adjust the Equalization for compatibility to
reduce the modem speed for fax operations.
1
Press Menu/Set, 2, 0, 1.
2
Press ▲ or ▼ to select Basic or
Normal or High.
Press Menu/Set.
3
Press Stop/Exit.
Note
■ Basic reduces the modem speed to 9600
bps. Unless interference is a recurring
problem on your phone line, you may
prefer to use it only when needed.
■ Normal sets the modem speed at 14400
bps.
■ High sets the modem speed at 33600 bps
■ When you change the Compatibility to
Basic, the ECM feature is not available.
Initial Setup
5.Dial Tone
Miscellaneous
1.Compatibility
To Next Page
Loading...
