Brother MFC-9420CN - Sequential Polling; Setup to Receive Delayed Polling

Polling
10 - 2
10
Setup to receive delayed
polling
You can set the machine to begin Polling
Receive at a later time.
1
If it is not illuminated in blue, press
(Fax).
2
Press Menu/Set, 2, 1, 8.
3
Press ▲ or ▼ to select Timer.
Press Menu/Set.
4
Enter the time (in 24-hour format) you
want to begin polling.
For example, enter 21:45 for 9:45 PM.
5
Press Menu/Set.
6
Enter the fax number you are polling.
Press Mono Start or Colour Start.
The machine makes the polling call at
the time you entered.
Note
■ You can set up only one Delayed Polling
operation at a time.
■ If the other fax machine that you are
calling has not been set-up for Polling, you
will receive the message
Connection
Fail
.
Sequential Polling
The machine can request documents from
several fax units in a single operation. You
just specify several destinations in Step 5.
Afterwards, a Sequential Polling Report will
be printed.
1 If it is not illuminated in blue, press
(Fax).
2
Press Menu/Set, 2, 1, 8.
3
Press ▲ or ▼ to choose Standard,
Secure or Timer.
Press Menu/Set when the screen
displays the setting you want.
4
If you selected Standard, go to Step
5.
• If you selected
Secure, enter a
four-digit number and press
Menu/Set, and then go to Step 5.
Note
If you did not enter the correct Secure Code,
you will receive the message
Disconnected.
• If you selected Timer, enter the time
(in 24-hour format) you want to begin
polling and press Menu/Set, and then
go to Step 5.
5
Specify the destination fax machines,
which you wish to poll by using
One-Touch, Speed-Dial, Search, a
Group (see Setting up Groups for
Broadcasting on page 7-5) or the dial
pad. You must press Menu/Set
between each location.
Setup Receive
8.Polling RX
Setup Receive
8.Polling RX