Chapter 5
5 - 4
Note
■ If you did not use up any of the numbers
for Groups, access codes or credit card
numbers, you can ‘broadcast’ faxes to as
many as 266 different numbers.
■ The available memory will vary depending
on the types of jobs in the memory and the
number of locations used for
broadcasting. If you broadcast to the
maximum numbers available, you will not
be able to use Dual Access and Delayed
fax.
■ Enter the long dialling sequence numbers
as you would normally, but remember that
each One-Touch and Speed-Dial number
counts as one number, so the number of
locations you can store becomes limited.
(See Access codes and credit card
numbers on page 7-6.)
■ If the memory is full, press Stop/Exit to
stop the job or if more than one page has
been scanned, press Mono Start to send
the portion that is in the memory.
To stop a broadcast in progress
1
Press Menu/Set, 2, 6.
The LCD will display the name, if you
stored it, or the fax number being
dialled.
2
Press Menu/Set.
The LCD will display:
3
Press 1 to Clear.
The LCD will then display the Broadcast
job number and
1.Clear 2.Exit.
4
To cancel the Broadcast, press 1.
5
Press Stop/Exit.
Additional Sending
Operations
Sending faxes using multiple
settings
When you send a fax you can choose any
combination of these settings: cover page,
contrast, resolution, overseas mode, delayed
fax timer, polling transmission or real time
transmission.
1
If it is not illuminated in blue, press
(Fax).
After each setting is accepted, the LCD
will ask if you want to enter more
settings:
2
Press 1 to select more settings. The
LCD will return to the
Setup Send
menu.
—OR—
Press 2 if you have finished choosing
settings and go to the next step.
XXXXXXXX
1.Clear 2.Exit
Next
1.Yes 2.No
To Next Page
Loading...
