Brother MFC-9420CN - Mode Timer; Paper Settings; Paper Type

Setup
3 - 6
3
Mode Timer
The machine has three temporary mode keys
on the control panel: Fax, Scan and Copy.
You can change the number of seconds or
minutes the machine takes after the last Scan
or Copy operation before it returns to Fax
mode. If you select
Off, the machine stays in
the mode you used last.
1
Press Menu/Set, 1, 1.
2
Press ▲ or ▼ to select 0 Sec,
30 Secs, 1 Min, 2 Mins, 5 Mins or
Off.
Press Menu/Set.
3
Press Stop/Exit.
Paper settings
Paper Type
To get the best print quality, set the machine
for the type of paper you are using.
1
Press Menu/Set, 1, 2.
—OR—
If you have the optional paper tray,
Press Menu/Set, 1, 2, 1 to set the paper
type for
Tray#1 or Menu/Set, 1, 2, 2 to
set the paper type for
Tray#2.
2
Press ▲ or ▼ to select Thin, Plain,
Thick, Thicker or Recycled Paper.
Press Menu/Set.
3
Press Stop/Exit.
Note
The machine ejects paper with printed
surfaces face down onto the output paper
tray in the front of the machine. When you use
transparencies or labels, remove each sheet
immediately to prevent smudging or paper
jams.
General Setup
1.Mode Timer
General Setup
2.Paper Type