Chapter 5
5 - 2
4
To send more than one page, press 1
and go to Step 5.
—OR—
To send a single page, press 2 (or press
Mono Start again).
The machine starts sending the
document.
5
Place the next page on the scanner
glass.
Press Menu/Set.
The machine starts scanning the page.
(Repeat Steps 4 and 5 for each
additional page.)
Note
■ If the memory is full and you are faxing a
single page, it will be sent in real time.
■ You cannot send multiple pages for colour
faxes.
Colour fax transmission
Your machine can send a colour fax to
machines that support this feature.
However, colour faxes cannot be stored in
the memory. When you send a colour fax, the
machine will send it in real time (even if
Real Time TX is set to Off).
Note
Delayed fax and Polling Transmit features
are not available in colour.
Cancelling a fax in progress
If you want to cancel a fax, while the machine
is scanning, dialling or sending it, press
Stop/Exit.
Dual Access
(Monochrome only)
You can dial a number, and begin scanning
the fax into memory—even when the
machine is sending from memory, receiving
faxes or printing PC data. The LCD shows the
new job number.
Note
■ Your machine normally uses Dual Access.
However, to send a colour fax, the
machine will send the document in real
time (even if
Real Time TX is set to
Off).
This means that you will have to wait until
the machine has finished sending the fax
before you can start scanning another.
The number of pages you can scan into
the memory will vary depending on the
data that is printed on them.
■ If you get an Out of Memory message
while scanning the first page of a fax,
press Stop/Exit to cancel scanning. If you
get an
Out of Memory message while
scanning a subsequent page, you can
press Mono Start to send the pages
scanned so far, or press Stop/Exit to
cancel the operation.
Next Page?
1.Yes 2.No(Send)
Set Next Page
Then Press Set
To Next Page
Loading...
