Chapter D
D - 5
6
Hold the SO-DIMM with your fingers on
the side edges and your thumb on the
back edge. Align the notch on the
SO-DIMM with the protrusions with the
SO-DIMM slot. (Check that the locks on
each side of the DIMM slot are open or
facing outwards.)
7
Press the SO-DIMM straight into the slot
(press firmly). Make sure the locks on
each side of the SO-DIMM click into
place.
Note
To remove the SO-DIMM, open the retaining
clips on both sides of the SO-DIMM by
pushing them outward, grasp both edges of
the SO-DIMM and pull it out straight.
8
Secure the metal plate with the screw.
9
Put the side cover back on by sliding it
into the guide rails, and then secure it
with the screw.
0
Reconnect the interface cable to your
computer. Then, plug the machine's
power cord back into the electrical
socket first, and then plug in the
telephone line cord. Turn on the
machine's power switch.
Note
To check that you have installed the
SO-DIMM properly, you can print the User
Settings listing that shows the current
memory size. To print the User Settings
listing, see How to print a report on page 9-2.
To Next Page
Loading...
