EasyManuals Logo

Brother MFC-L2700D Service Manual

Brother MFC-L2700D
307 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #254 background imageLoading...
Page #254 background image
5-10
Confidential
<Operating Procedure>
Note:
• To cancel operation and return to the initial state of maintenance mode, press the [X] or
[Stop] key.
• If there is no entry for one minute or longer after entering the first digit on 2-digits worker
switch number selection, the machine returns to the initial state of maintenance mode
automatically.
For models without keypad
(1) Press the [â–²] or [â–¼] key in the initial
state of maintenance mode to display
"MAINTENANCE 10" on the LCD, and
press the [OK] key. "WSW00" is
displayed on the LCD.
(2) Press the [â–²] or [â–¼] key to display the
worker switch number for which you
want to change the setting on the LCD.
(3) Press the [OK] key. The following
display appears on the LCD.
(4) Pressing the [â–²] key enters "1", and
pressing the [â–¼] key enters "0". Press
either to enter desired number to
Selector No.1. The next digit starts
flashing.
(5) Keep entering numbers to Selector No.8
using the [â–²] or [â–¼] key as described in
the procedure (4).
(6) Press the [OK] key. The new selector
setting value is stored in the EEPROM,
and the LCD returns to the ready state
for worker switch number entry
("WSW00").
(7) When all switch setting is completed,
press the [Stop] key to return the
machine to the initial state of
maintenance mode.
For models with keypad
(1) Press the [1], and then the [0] key in the
initial state of maintenance mode.
"WSW00" is displayed on the LCD.
(2) Enter the worker switch number that you
want to change the setting. The
following display appears on the LCD.
(3) Press the [ ] or [ ] key to move the
cursor to the desired selector, and
change the setting by pressing the [1] or
[0] key.
(4) When changing the setting is
completed, press the [SET] or [OK] key.
The new selector setting value is stored
in the EEPROM, and the LCD returns to
the ready state for worker switch
number entry ("WSW00").
(5) When all switch setting is completed,
press the [X] or [Stop] key to return the
machine to the initial state of
maintenance mode.
WSWXX = 0 0 0 0 0 0 0 0
Selector No. 1 Selector No. 8
WSWXX = 0 0 0 0 0 0 0 0
Selector No. 1 Selector No. 8

Table of Contents

Other manuals for Brother MFC-L2700D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brother MFC-L2700D and is the answer not in the manual?

Brother MFC-L2700D Specifications

General IconGeneral
Print TechnologyLaser
Print ResolutionUp to 2400 x 600 dpi
Duplex PrintingYes
Paper Input Capacity250 sheets
Monthly Duty CycleUp to 10, 000 pages
FunctionsPrint, Copy, Scan, Fax
ADF Capacity35 sheets
Memory32 MB
Fax Speed33.6 Kbps
Print SpeedUp to 27 ppm
ConnectivityUSB 2.0
Scanner TypeFlatbed
Copy SpeedUp to 27 cpm
Scan ResolutionUp to 600 x 2400 dpi
Display2-line LCD

Related product manuals