6-72 Confidential
• Mount the switching lever guide and the mode switching lever & clutch gear ASSY onto the
engine unit in this order.
Before mounting the ASSY, apply the specified lubricant to the specified points, referring to
Section 6.2.
When mounting the ASSY, insert the shaft end into the hole provided in the CR guide rail and fit
the right hook over the cutout (see page 6-67).
The ASSY should be mounted immediately before you mount the maintenance unit.
• Before mounting the maintenance unit onto the engine unit:
- Apply the specified lubricant to the SF changeover gear and the purge gear shaft, referring to
Section 6.2.
- Put the two gears (SF changeover gear and HS changeover gear) together so that there is a gap
between those gears as shown on page 6-67. Then set them onto the purge gear shaft with the
HS changeover gear (thinner one) facing towards the maintenance unit.
• When securing the maintenance unit with three screws (two "a" and one "b" screws), tighten
these screws in the order of  to  as shown on page 6-67.
To Next Page
Loading...
Need help?
General
