8
HYPERION User Manual Bruker Optik GmbH
Safety 1
1.4 Intended use
The microscope HYPERION is intended for the microscopic examination and FT-IR
spectroscopic analysis of micro-samples, small sample areas and inhomogeneous sam-
ples. For the FT-IR spectroscopic analysis, the microscope needs to be coupled to a FT-
IR spectrometer of the TENSOR or VERTEX series. It is suited for all kinds of solid sam-
ples which absorb infrared light (radiation energy).
It is intended for the use in a laboratory under the environmental conditions specified in
appendix A.1.
The intended use includes also the compliance with the relevant standards and
regulations, especially:
• regional or national safety regulations
• regional or national accident prevention regulations
• generally recognized technical regulations
The intended use also includes the strict observance of all instructions given in this
manual, namely:
• safety instructions
• installation instructions,
• operation instructions
• repair and maintenance instructions
Use only components and accessories supplied by Bruker. For components and acces-
sories made by other manufacturers and used in conjunction with the microscope,
Bruker Optik GmbH does not assume any liability for safe operation and proper function-
ing.
1.5 Service contact data
In case you have questions about safety, installation and/or operation as well as repair
and maintenance of the analysis system or you need technical assistance in case of a
hardware and/or software problem, you can contact the Bruker service as follows:
• Service Hotline Hardware: +49 (0) 72 43 504-2020
• Service Hotline Software: +49 (0) 72 43 504-2030
• Fax: +49 (0) 72 43 504-2100
• E-Mail: service.bopt.de@bruker.com
service.bopt.us@bruker.com
☞ On our website www.bruker.com/about-us/offices/offices/bruker-optics you will
find also the current contact data of all Bruker Optics service offices worldwide.
WARNING
Health hazard because of unintended use of the microscope
Non-observance of the following safety instruction could result in injury and/or micro-
scope damage.
➣ Do not take any actions that violate the intended use. The operational safety of
the microscope is ensured only if it is used as intended.
To Next Page
Loading...
Need help?
General