55
Bruker Optik GmbH HYPERION User Manual
4Operation
4.1 General information
Before you start to work with the HYPERION microscope for the first time, it is
highly recommended to familiarize yourself with the operating elements of the
microscope and the relevant OPUS functions.
For information about ...: refer to ...:
operating elements of the microscope chapter 3 in this manual
how to perform a video-assisted mea-
surement
OPUS/VIDEO Manual
software-controlled operation of the
motorized stage and resetting the motor-
ized stage to its home position
OPUS/MAP and OPUS/VIDEO Manual
how to set up the mapping device and
the imaging device in OPUS
OPUS/VIDEO Manual
measurement parameters appendix B in this manual and the OPUS
reference manual.
how to operate the ATR objective section 4.12 in this manual
how to operate the motorized knife-edge
aperture
OPUS/VIDEO Manual
how to perform continuous scan mea-
surements with the FPA detector
OPUS/FPA Manual
how to validate
a
the analysis system (i.e.
FT IR spectrometer plus HYPERION
microscope)
a. Validating means performing a PQ test (Performance Qualification) and/or an OQ test (Operational Qualifi-
cation) using OVP.
Procedure Guide OVP Test Procedure
Guide and VALIDATION Manual
b
For general information about OVP
c
refer
to the OPUS Reference Manual.
b. This VALIDATION Manual is only included in the delivery scope of a validated analysis system.
c. OVP - O
PUS Validation Program (It is integral part of the OPUS software.)
To Next Page
Loading...
Need help?
General