Bruker HYPERION - Operating Panel

To Next Page

To Previous Page

Bruker Optik GmbH HYPERION User Manual

Overview 3

3.3 Operating panel

Figure 3.4: Operating panel

Fig. 3.4 Control element and explanation

A VIS/IR button: to activate the viewing and measuring mode.

Note: With this mode being activated, the sample can be viewed by means of the bin-

ocular or on the monitor and a spectroscopic measurement can be performed. Acti-

vating this button automatically deactivates the VIS button and the IR button.

B VIS button: to activate the viewing mode.

Note: With this mode being activated, the sample can only be viewed by means of

the binocular or on the LCD monitor. Performing a spectroscopic measurement is not

possible. Activating this button automatically deactivates the VIS/IR button and the IR

button.

C IR button: to activate the measuring mode.

Note: With this mode being activated, only spectroscopic measurements can be per-

formed, e.g. by operating the START button (H in fig. 3.4). Sample viewing is not pos-

sible. Activating this button automatically deactivates the VIS button and the VIS/IR

button.

D Brightness indicator: indicates the current brightness intensity of the visible illumi-

nation in relation to the maximum possible brightness intensity by means of a bar

graph display.

Note: The brightness intensity can be adjusted by means of a thumb wheel (B in

fig. 3.5).

E Reflection mode button: to activate the reflectance mode for reflection microscopy

and spectroscopic measurements in reflection. Use this mode in case of a reflecting

sample.

Note: Activating this button automatically deactivates the transmittance mode button.

F Transmission mode button: to activate the transmittance mode for transmission

microscopy and spectroscopic measurements in transmission. Use this mode in case

of a transparent sample.

Note: Activating this button automatically deactivates the reflectance mode button.