Bruker HYPERION - Safety; General Safety Information

5
Bruker Optik GmbH HYPERION User Manual
1 Safety
1.1 General safety information
1.2 Classification of the safety notes
Depending on the degree of hazard, important safety notes are classified in this manual
by signal words as follows:
➣ Read carefully all instructions and safety notes in this manual before installing,
putting the microscope into operation or maintaining it. Keep this manual for future
reference available at any time.
➣ Always observe the instructions and safety notes given in this manual. Failure to
do so can lead to personal injuries and/or property damage. Non-observance of
the instructions and safety notes will violate the intended use of the microscope.
(See section 1.4.)
➣ It is the operator's duty to plan and implement all necessary safety measures and
to supervise their observance. Moreover, the operator must ensure that the micro-
scope is in proper condition and fully functioning.
➣ A safe and trouble-free operation of the microscope is ensured only if all compo-
nents of the analysis system are installed and operated as well as maintained and
repaired according to the procedures described in this manual and in compliance
with all relevant safety standards and regulation.
➣ The microscope should be operated only by authorized personnel which is trained
in operating the microscope and which is familiar with the relevant safety instruc-
tions. Never remove or deactivate any supporting safety systems during micro-
scope operation. Objects and/or material not required for the operation should be
kept outside the operating area of the microscope.
➣ The microscope complies with the IEC/EN 61010-1 safety regulations.
WARNING
➣ Indicates a hazardous situation which, if not avoided, could result in death or seri-
ous (possibly irreversible) injury and major property damage.
CAUTION
➣ Indicates a hazardous situation which, if not avoided, may result in minor or mod-
erate (reversible) injury.
NOTE
➣ Hazard, which could result in material damage if the appropriate safety instruc-
tions are not observed.