Bruker HYPERION - Connecting the FPA Detector

20
HYPERION User Manual Bruker Optik GmbH
Installation 2
2.7.6 Connecting the FPA detector
Only HYPERION 3000 can be equipped with a FPA detector.
The following cables are included in the delivery scope of the FPA detector: :
• Signal cable
• Trigger cable
• Power supply cable (including external power supply unit)
Bottom side of the FPA detector compartment
A
Figure 2.2: Cable connectors of the FPA detector
E
D
B C
Fig. 2.2 Sockets and switches
A ON / OFF switch
B Outlet of the signal cable
CLED
Note: This LED lights green when the FPA detector is switched on.
D Socket for connecting the trigger cable
E Socket for connecting the power supply cable