21
Bruker Optik GmbH HYPERION User Manual
Installation 2
1 Connect the signal cable of the FPA
detector to the corresponding socket at
the PC.
2 Connect the trigger cable to the RS42
Sync Input socket
② at the bottom side
of the FPA detector compartment as well
as to the corresponding socket
③ at the
spectrometer rear side.
➣ Attention: Before connecting the
trigger cable, make sure that the
spectrometer is switched off!
Note: In case of a spectrometer of the
TENSOR series, a distributor box is
required.
3 Connect the power supply cable to the
Power socket
④ at the bottom side of
the FPA detector compartment.
The power is supplied by a dedicated
external power supply unit. Connect this
external power supply unit to a mains
socket outlet.
Important note: Connect the power sup-
ply cable only to a socket outlet with
earthing contact
⑤. Make sure that the
socket complies with IEC.
To Next Page
Loading...