Bruker HYPERION - LCD Monitor

46
HYPERION User Manual Bruker Optik GmbH
Overview 3
3.11 LCD monitor
The following microscope variants are equipped by default with a high-resolution, color
LCD monitor: HYPERION 2000 and HYPERION 3000.
Figure 3.17: a) HYPERION 2000 (front side) b) Right microscope side- Operating elements of the LCD monitor
A
B
C
D
E
F
Fig. 3.17 Component and explanation
A LCD monitor: allows for a comfortable sample viewing of the video image in real
time.
Note: The sample can be viewed on the LCD monitor also during a IR spectro-
scopic measurement, providing that the VIS/IR mode (A in fig. 3.4) is activated.
B UP button and DOWN button: Use these two buttons to adjust the value of the
currently selected parameter (e.g. brightness, contrast etc.).
C Menu button: to open the menu for adjusting display parameters (e.g. brightness,
contrast etc.) for den LCD monitor.
D Input signal switch
This switch is inactive. Actuating this switch has no effect.
E ON / OFF switch: to switch on / off the LCD monitor
F LED display of the switching status of the LCD monitor
red LED: LCD monitor is switched off.
green LED: LCD monitor is switched on.