13
Bruker Optik GmbH HYPERION User Manual
Installation 2
2.6 Connecting the microscope to the power supply
2.6.1 General information
The microscope power supply is realized by an external power supply unit. The external
power supply unit plus power cord and low-voltage cable are included in the standard
delivery scope of the microscope.
☞ For information about the power supply requirements, see section 2.5.
i
Depending on the local conditions, the original power cord may need to be exchanged
for a power cord that complies with the standards of the country in question. Ensure that
the installed power cord has the approval of the local authority (e.g. UL for US, CSA for
Canada or VDE for Europe).
2.6.2 Safety note
CAUTION
Injury and/or property damage due to non-observance of the following
safety instructions regarding the external power supply unit
To ensure a safe operation of the external power supply unit, observe the following
safety instructions:
➣ If the external power supply unit is damaged disconnect it instantly from the sup-
ply circuit. Never put a damaged external power supply unit into operation! Only
authorized technicians are allowed to repair the external power supply unit!
➣ Operate the external power supply unit only in a dry environment.
➣ Make sure that the external power supply unit is not exposed to direct sunlight.
Avoid temperatures above +50 °C. Provide for sufficient air circulation.
➣ Position the external power supply unit in such a way that it does not present a trip
hazard.
➣ Do not put heavy objects on the external power supply unit.
➣ Do not place the external power supply unit on a hot surface.
To Next Page
Loading...
Need help?
General