Bruker HYPERION - Connecting the Microscope to the Spectrometer

To Next Page

To Previous Page

HYPERION User Manual Bruker Optik GmbH

Installation 2

2.7.7 Connecting the microscope to the spectrometer

The CAN BUS cable is included in the standard

delivery scope of the microscope.

Note: Via this CAN BUS connection, the motor-

ized mode mirrors inside the microscope are

controlled in case the modes (transmission

mode / reflection mode and viewing mode /

measurement mode) are to be activated by the

corresponding OPUS/VIDEO functions and not

by pressing the corresponding buttons at the

microscope control panel.

①

1 Connect the CAN BUS cable to the CAN

BUS socket

② at the spectrometer rear

side and to one of the three CAN BUS

sockets

③ at the microscope rear side.

Note: The three CAN BUS sockets at the

microscope rear side are labeled

ACC.CONTROL. Connect the CAN BUS

cable to one of them.

②

③