Bruker HYPERION - Measuring a Sample with the ATR Objective (Mapping Measurement)

To Next Page

To Previous Page

Bruker Optik GmbH HYPERION User Manual

Operation 4

4.14 Measuring a sample with the ATR objective (mapping

measurement)

Special technical requirements

For performing a spectroscopic measurement using the ATR objective, the following

hardware and software components are required:

Configuring the mapping device and the imaging device - Specials

For performing a mapping measurement with the ATR objective, special components

and options need to be selected in OPUS when configuring the mapping device and the

imaging device.

☞ For detailed information about how to configure the mapping device and the imag-

ing device, refer to the OPUS/VIDEO Manual.

Hardware • ATR objective with focus sensor (end switch for stage

movement in z- direction)

• motorized x/y/z-stage with computer-controlled focussing

assembly (option A673-FA)

Software • optional software package OPUS/ATR (for controlling the

stage movement in z-direction)

Mapping device • lstepATRMICstage

Imaging device An imaging device especially intended for ATR mapping

measurements must include the following components:

• Microscope/Device: Hyperion2000 or Hyperion3000 or a

HYPERION1000 microscope which has been upgraded

with a motorized x/y/z-stage and the option A673-FA

• Objective: 20x ATR

• Electronic options: Autofocus

• Motorized X/Y stage: lstepATRMICstage