Bruker HYPERION - Page 110

108
HYPERION User Manual Bruker Optik GmbH
Operation 4
7. Microscope: Activate the measuring
mode.
either using the IR button on the operat-
ing panel of the microscope (C in fig. 3.4)
or in the OPUS video wizard
☞ See OPUS/VIDEO Manual.
8. If available, use a polarizer for p-
polarized light.
Note: For background information
about this topic, refer to section 5.1.2.
☞ For information about the location of
the slots for inserting a polarizer, see
section 5.4.3.
9. Start background measurement. corresponding OPUS function
☞ See OPUS/VIDEO Manual.
10. Move the stage downwards.
Exchange the mirror for the sample.
Manual stage and motorized x/y-stage:
coarse and fine focus knobs at the micro-
scope (B/B’ and C/C’ in fig. 3.7)
Motorized x/y/z-stage: Joystick and cor-
responding stage control functions in
OPUS
☞ See OPUS/VIDEO Manual.
11. Set the mirror optics of the GIR
objective to the viewing mode (VIS).
GIR objective (fig. 4.4)
☞ See section 4.15.3.
12. Microscope: Activate the viewing
mode.
either the VIS button on the operating
panel (B in fig. 3.4) or in the OPUS video
wizard
☞ See OPUS/VIDEO Manual.
Operating step Corresponding operating element(s)