168
HYPERION User Manual Bruker Optik GmbH
Measurement parameters B
Modifying an experiment file
Normally, the default parameter settings (especially the optics parameter) of the deliv-
ered experiment files need to be adapted to configuration of the analysis system in ques-
tion. To do this, proceed as follows:
1. Select in the OPUS Measure menu the Video-assisted measurement function.
2. Load a supplied experiment which is appropriate for the measurement mode and
the measurement technique (transmission, reflection, mapping measurement
1
,
measurement with ATR objective, measurement with FPA detector
2
) you intend to
perform.
3. Select the corresponding parameter options. (See the following sections.)
4. Save the modified parameter settings. To do this, click in the Video assisted Mea-
surement dialog on the Advanced tab. On this dialog page, click on the Save button.
(Note: It is advisable to save the modified experiment file with a different file name.)
Information about the optics parameter
To modify the optics parameter, click on the Optics tab. See the following figure.
1. Mapping measurements are only possible if the microscope is equipped with a motorized sample stage.
2. The FPA detector is only available for the microscope variant HYPERION 3000.
Figure A.1: OPUS dialog Video assisted Measurements - Dialog page Optics parameter
To Next Page
Loading...