Brunswick StringPin - Section 5 - Maintenance & Service; Routine Maintenance and String Repair; Installing New String; Motor Replacement

StringPin Pinsetter Service Manual 5
Section 6 - Troubleshooting ................................................................................................. 6-1
Solutions to Common Problems ................................................................................................. 6-1
1. Machine and Accelerator Will Not Run .......................................................................... 6-1
2. One Machine Does Not Run ........................................................................................... 6-1
3. Accelerator Will Not Run ................................................................................................ 6-1
4. Machine Will Not Stop After Completing a Cycle .......................................................... 6-1
5. Machine Starts and Stops When Attempting to Lift Pins ................................................ 6-1
6. The Pinsetter Respots One or More of the Fallen Pins. Scorer Scores Correctly. ......... 6-2
7. The Brake in the PMI Does Not Release To Allow the Pin(s) To Lower
To the Pindeck. ............................................................................................................... 6-2
8. A Machine is Malfunctioning But You Cannot Isolate the Problem ............................... 6-2
9. Pins Fall When Being Spotted ........................................................................................ 6-2
10. Pins Are Not Respotted Accurately ............................................................................... 6-2
11. The Pinsetter Shows a Home Switch ............................................................................. 6-2
Clearing Error Codes and Correcting Pinsetter Stop .................................................................... 6-3
Error Codes Description, Causes, And Solutions ......................................................................... 6-4
Problem/Cause/Corrective Action ................................................................................................. 6-5
Section 7 - Cables ................................................................................................................. 7-1
String Pinsetter Pin Motion Interface Harness (P/N 55-143009-000) ................................. 7-1
String Pinsetter Switch Cluster Cable (P/N 55-143010-000) ............................................... 7-1
String Pinsetter Motor Cable (P/N 55-143011-000) ............................................................ 7-1
String Pinsetter Controller to Pin Motion Interfaces - Rear Mount Cable
(P/N 55-143012-XXX) ......................................................................................................... 7-2
Emergency Stop Box and Cable - Rear Mount (P/N 55-143013-XXX) .............................. 7-2
Ball Accelerator Overload Cable - Rear Mount (P/N 55-143014-XXX) ............................. 7-2
1st/2nd Ball LED Lights Masking Unit Cable - Rear Mount (55-143015-XXX) ................ 7-3
Foul/Ball Lift/Ball Detect Harness - Rear Mount (55-143016-000) .................................... 7-3
Foul/Ball Lift/Ball Detect Harness - Front Mount (55-143016-100) ................................... 7-3
Foul/Ball Lift/Ball Detect Harness - Rear Mount Separated Lane (55-143016-200) .......... 7-4
String Pinsetter Mechanic’s Stop Switch Cable (55-143017-000) ....................................... 7-4
String Pinsetter Motor Overload Cable (55-143018-000) .................................................... 7-4
String Pinsetter Trouble Light Cable (55-143019-000) ....................................................... 7-4
String Pinsetter Motor Power Cable - Rear Mount (55-143067-XXX) ............................... 7-5
String Pinsetter Switch Cluster EXT Cable - Rear Mount (55-143068-XXX) .................... 7-5
String Pinsetter DC Pinlight Cable (55-143069-000) .......................................................... 7-5
StringPin Controller - UL Version ........................................................................................ 7-6
StringPin Controller - CE Version ........................................................................................ 7-7