Brunswick StringPin - Section 4 - Adjustments; Switch Cluster Adjustments; Pins up Switch Adjustment

Section4:Adjustments 4-1
Section 4 - Adjustments
SWITCH CLUSTER ADJUSTMENTS
Pins Up Switch Adjustment
The purpose of the Pins Up switch adjustment is to make sure that the string wagon catches on the stop
dogs properly when the Pins Up or Setup selection on the StringPin Controller is selected to raise the
pins. This position of the string wagon and pins is used when making other adjustments such as the
string tension adjustment.
1. Return All Pins to the Pins Up Position
a. Place the Stop/Run switch on the Controller to the “Stop” position.
b. On the Pinsetter Mode drop down menu, select Pins Up or Setup. Figures4-1aand4-1b.
c. Place the Stop/Run switch on the Controller to the “Run” position.
(1)
MODE DROP
DOWN MENU
(1)
MODE DROP
DOWN MENU
(2)
PINS UP
Figure4-1a.SelectPinsUpMode(Versions1.1.14andPrior)
(1) MODE DROP DOWN MENU (2) PINS UP
(1)
MODE DROP
DOWN MENU
(1)
MODE DROP
DOWN MENU
(2)
SETUP
Figure4-1b.SelectPinsUpMode(Versions1.1.15andLater)
(1) MODE DROP DOWN MENU (2) SETUP