Brunswick StringPin - Page 53

Section 3: Pinsetter Electronics 3-13
The items that appear on the Pinsetter Mode Drop Down Menu include:
(1) Mode Drop Down Menu - Select the down arrow to expand the expand the pinsetter mode
menu.
(2) Mode Selections - The menu has the following selections:
• Standalone (2-Ball) - The 2-Ball Stand alone mode runs independent of the scoring
system. In this mode the pinsetter will operate in a 2 balls per frame mode but will not
communicate with or provide scoring information to the scoring system (if installed).
• Standalone (3-Ball) - 3-Ball Standalone mode, runs independent of the scoring system. In
this mode the pinsetter will operate in a 3 balls per frame mode but will not communicate
with or provide scoring information to the scoring system (if installed).
• Scorer Control - Scoring dependent mode. In this mode the pinsetter will operate in a
designated frame mode but will communicate with and provide scoring information to the
scoring system. While in this mode, the scoring system dictates all pinsetter operation.
• Diagnostics - While in this mode the pinsetter will run a continuous cycle until the user
exits the mode or a pinsetter error condition occurs. During operation, the pinsetter spots
and retracts each individual pin in sequence.
• Ball Return Only - Turns on the ball return for diagnosis and adjustment of the ball
accelerator and the ball lift.
• Pins Up - When this option is selected, the pinsetter lifts all 10 pins to up position so that
the string wagon can stop on the stop dogs. Normally this is used when performing the
string tension adjustment.
NOTE: ThePinsUpmodeisonlyavailableinrmwareversions1.1.14andprior.Ifthe
rmwareis1.1.15orlater,pleaseseethenextsectionfortheexplanationofthedropdownmenu
modes.
• Pinlight On - When selected, this option causes the pinlight to turn “ON”. Typically this
feature is used to provide additional light for the mechanic when performing maintenance
of the pinsetter.