Bticino D45 Technical Guide

SONORA - CARATTERISTICHE GENERALI
20
VIDEO DOOR ENTRY SYSTEM - GENERAL FEATURES
D45
Ring volume/ silent mode setup
While in standby, adjust ring adjustment knob to change
the ringing volume. When call light turns red, it means the
ring volume is at minimum level and the system is in silent
mode. Whilst in silent mode, if a call is received the handset
call light will flash quickly but the handset will not ring.
When the light is blue it means that the handset is in normal
ringing mode.
Brightness and contrast or colour setup
While the device is showing the picture from EP camera or
Small EP camera, adjust the brightness and color or contrast
adjustment knob to change the brightness and contrast or
colour.
Installation instructions (for the installer)
set the hanDset room no.
There are two ways to set the room number for colour handsets:
n Set room number #FFII using congurators. This method
has high priority. Each time the congurator is changed,
the power needs to be disconnected and reconnected
again to activate the congurator. To set room number
0806, insert congurators 0, 8, 0, 6 in the relevant sockets
(for the detailed operations please refer to the system
conguration chapter).
Note: if the room number is set beyond the apartment numbers of each floor,
then the settings will be consider as ineffective.
n Set the room number using the keyboard. This method has
low priority. This means that if the congurator method is
also used, the handset will accept the parameters from
the congurator rst.
n 322040 handset can only be congured using the
keyboard.
Setting the number of apartments per
floor
1. Set the apartment number #II using configurators.
This method has high priority. Every time after change
configurator, the power need be cut and reconnected
to active the configurator. To set apartment number 6,
insert configurators 0 and 6 in the relevant sockets on
the back of the handset (for the detailed operations
please refer to the system configuration chapter).
2. Set the floor apartment number using the keyboard.
This method has low priority. This means that if the
configurator method is also used, the handset will
accept the parameters from the configurator first.
3.
Note: if not set, the default floor apartment number will be 4.
Indoor handset functions overview

Bticino D45 Specifications

General

Brand	Bticino
Model	D45
Category	Intercom System
Language	English