Buderus Logamatic 4323 - Page 23

Commissioning the MEC2 programming unit
6
Logamatic 4323 - Subject to technical modifications.
23
Press "AUT" = "Data are to ctrl unit sent".
The display will then show the adjacent message.
Press "Night mode" = "Data are from ctrl unit taken".
The display will then show the adjacent message.
c) Identical control unit
If the MEC2 programming unit is separated from the control unit and data is also
modified, the display shows "Aut button transmit, Night button receive", when
the unit is reinstalled into the same control unit. The control unit scans whether
the new data should be accepted or whether the old data from the control unit
should be used again.
Press "AUT" = "Data are to ctrl unit sent".
The display will then show the adjacent message.
Press "Night mode" = "Data are from ctrl unit taken".
The display will then show the adjacent message.
Data are
to ctrl unit
sent
Data are
from ctrl unit
taken
Aut button
transmit
Night button
receive
Data are
to ctrl unit
sent
Data are
from ctrl unit
taken