23
MicroDock II
Installation
Note
The detector will briefly alarm when the pump connector is
inserted. This is normal. The alarm will deactivate when the
detector is properly inserted into the docking module.
Ensure green is visible in the closed indicator. If it is not visible,
the base station will not recognize the detector.
6. Lower the lid and press down until the release tabs click.
When the detector has been inserted correctly, the RUN LED(s)
on the docking module lights yellow and the base station LCD
displays the
• the docking module number,
• Unit Inserted,
• detector type, and
• detector serial number.
7. To bypass the base station identification screen, press any
C
button on the base station.
To Next Page
Loading...
