SERVICE PROCEDURES 72
4. Power on the imagePRESS Server and allow it to boot without interruption.
If a monitor is connected to the imagePRESS Server:
• At the Log On to Windows dialog box, type
Administrator in the user name field, type
Fiery.1 in the password field, and then press Enter on the keyboard. Type Fiery.1 exactly as
shown. The password is case-sensitive; for example,
fiery.1 will not work.
At this point, the imagePRESS Server is in Service Mode, so you can verify that the new
motherboard solves the problem that you are trying to troubleshoot. Service Mode is not
indicated on the monitor or the imagePRESS Server Control Panel.
5. Print the imagePRESS Server Test Page (see page 40).
6. Ask the network administrator to connect the imagePRESS Server to the network and
download a print job over the network (see Configuration and Setup on the User
Documentation CD).
If the problem that you are troubleshooting persists, or if you are unable to perform steps 4
through step 6 above while in Service Mode, you may conclude that the old motherboard was
not the source of the problem and does not need to be replaced. If so, do not transfer options
to the new motherboard (described on page 73), do not install system software, and do not
replace the HDD. Reinstall the old motherboard and return the new motherboard with the
unexpended one-time use dongle to inventory. For more information about troubleshooting
system problems, see “Troubleshooting” on page 110.
If installing a new motherboard solved the problem that you are troubleshooting and you
are able to print a Test Page and send a print job over the network, you are ready to transfer
options to the new motherboard. Service Mode ends automatically when you transfer options
to the new motherboard (see page 73).
To Next Page
Loading...
