When specifying an IPv6 IP address
1
Start imagePROGRAF Device Setup Utility from the
start menu.
2
In the Device Name list displayed, select the printer to configure.
3
Choose Protocol Settings from the Printer menu.
4
Select the IPv6 tab.
5
In IPv6, select On.
6
When there is an IPv6-compatible router in the network environment, select On in Stateless Address.
Additionally, when there is an DHCPv6-compatible server in the network environment, select On in DHCPv6.
Note
• When there is no IPv6-compatible router or DHCPv6-compatible server, select On in Manual and enter the IPv6
Address and Prefix Length.
7
Click Set.
8
Click OK after the Confirmation message is displayed.
9
Exit imagePROGRAF Device Setup Utility.
Configuring the IP Address Using imagePROGRAF Device Setup Utility
iPF765
User's Guide
Windows Software Device Setup Utility
310
To Next Page
Loading...
