Setting Item Description, Instructions
Paper Details (The type of paper
is displayed here.)
(*1)
CutDustReduct. If you choose On, a line will be printed at the cut position when paper
cutting is selected. This option reduces the amount of debris given off
after cutting. It also helps prevent adhesive from sticking to the cutter
and keeps the cutter sharp if you use adhesive paper. (See "Reducing
Dust from Cutting Rolls.") →P.464
VacuumStrngth Specify the level of suction that holds paper against the Platen. (See
"Adjusting the Vacuum Strength (VacuumStrngth).") →P.617
Scan Wait Time Specify the time to wait for the ink to dry between each scan (after the
printhead finishes moving in one direction), in consideration of how
quickly the ink dries. Also specify the applicable area for the ink drying
time. Select Entire area to apply the ink drying time after each scan un-
til the document is fully printed. Select Leading edge to apply the ink
drying time after each scan only in the area 110–140 mm from the lead-
ing edge. (The applicable length varies depending on the Print Quality
setting.) Note that printing will take longer if you specify the Scan Wait
Time setting. In particular, when Leading edge is selected, colors may
be uneven in the boundary between the areas with and without a drying
time.
Roll DryingTime Specify the time to wait for the ink to dry for each sheet.
NearEnd RollMrgn Specify the minimum margin at the leading edge of roll paper to ensure
better printing quality at the leading edge.
Note that if you choose 3mm, it may lower the printing quality at the
leading edge and affect feeding accuracy. The printed surface may be
scratched, and ink may adhere to the leading edge. It may also cause
the Platen to become soiled.
NearEnd Sht Mrgn Specify a margin at the leading edge of sheets to ensure better printing
quality at the leading edge.
Note that if you choose 3mm, it may lower the printing quality at the
leading edge and affect feeding accuracy. The printed surface may be
scratched, and ink may adhere to the leading edge.
Bordless Margin Adjust the margin during borderless printing.
Choose Automatic to have the printer automatically detect the paper
width and configure the margin settings for borderless printing. If mar-
gins are mistakenly created when Automatic is selected, choose
Fixed. In this case, the paper width is not detected automatically, and
the document is printed without borders, using the margin settings re-
quired by the printer.
Width Detection Specify this option to print inside boundaries or in other cases when
specifying a particular starting position for printing. (See "Printing From
a Desired Starting Point.") →P.467
Paper width and skew are not detected if you select Off. If paper is loa-
ded askew, note that paper jams or Platen soiling may occur.
Return Defaults Choose OK to restore Paper Details to the default values.
Paper Details Print the paper settings as specified in Paper Details.
Keep Paper Type Select On when printing on a particular type of paper regularly. (See
"Changing the Type of Paper.") →P.449
*1: For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See "Types of Paper.") →P.438 The
types of paper indicated in the printer driver and related software (as well as on the Control Panel) are updated when you install the
printer driver from the User Software CD-ROM or if you update paper information by using the Media Configuration Tool. (See Media
Configuration Tool Guide (Windows) →P.311 or Media Configuration Tool Guide (Macintosh) →P.420 .)
iPF765
Menu Settings
User's Guide
Control Panel Printer Menu
501
To Next Page
Loading...
Need help?
General
Weight and Dimensions
