Naming Conventions for Accessories (Generic Naming
in User Interfaces)
Generic Naming of Accessories in User Interfaces
To improve the readability of texts in User Interfaces of control panels and software, the
accessories are generally referred to by their function. The table below shows the naming
conventions for accessories (commercial product names and the generic terminology used in
User Interfaces). Some accessories listed below may not be available in certain markets.
NOTE
In some cases, there is only 1 name for more modules. The reason is that a configuration can
only contain 1 of the available types of modules.
Conversion table for commercial names versus generic terminology in User Interfaces
Commercial product name: In UI, printer driver and software referred to
as:
Finisher-AF1 and Finisher-AK1 [Stacker/stapler]
Saddle Finisher-AF2 and Saddle Finisher-AK2 [Stacker/stapler]
Puncher Unit-BP1/BQ1/BR1 and Puncher Unit-
BT1/BU1/BS1
[Puncher]
Professional Puncher-B1 [Puncher]
Paper Folding Unit-F1 [Folder]
Document Insertion Unit-F1 [Inserter]
High Capacity Stacker-E1 [Stacker]
High Capacity Stacker-F1 [Stacker]
High Capacity Stacker-G1 [Stacker]
Booklet Trimmer-D1 [Trimmer]
Two-Knife Booklet Trimmer-A1 [Trimmer]
Perfect Binder-C1 [Perfect Binder]
Duplex Color Image Reader Unit-D1 [Scanner]
Decurler Unit-A1 [Decurler]
NOTE
High Capacity Stacker-E1 and High Capacity Stacker-F1 cannot be combined.
High Capacity Stacker-E1 and High Capacity Stacker-G1 cannot be combined.
Finisher-AF1/Saddle Finisher-AF2/Puncher Unit-BP1/BQ1/BR1 and Finisher-AK1/Saddle Finisher-
AK2/Puncher Unit-BT1/BU1/BS1 cannot be combined.
Naming Conventions for Accessories (Generic Naming in User Interfaces)
12
Chapter 1 - Preface
Canon varioPRINT 135 Series
To Next Page
Loading...
