Combining subsets into one document
Introduction
You can copy or scan several sets of originals to one document or file with subsets. With the
optional [Page programming] function, you can add pages, for example, tab sheets, and define
the media and finishing settings for each page and subset.
Procedure
1.
Place the first subset face up into the ADF.
2.
Touch [Jobs] -> [Copy/Scan] -> [Combined copy job].
3.
Define the subset settings for both in the [Original] and [Output].
NOTE
Some settings that you define for the first subset apply to the whole job, the [Type] and
[Resolution] settings, for example. These settings are fixed and are grayed out after scanning the
first subset.
4.
Press [Scan].
5.
Put the next subset into the automatic document feeder or on the glass plate.
6.
Repeat steps 3 to 5 for all subsequent subsets.
A number indicates the order in which the subsets have been scanned.
NOTE
When you combine 1-sided and 2-sided originals, you can define whether a new subset must
continue on a new sheet or on the previous sheet.
7.
Touch [Ready] when the last subset is scanned and processed.
A full overview of all the scanned subsets appears in the right-hand pane. If required, you can
add, insert, delete or edit subsets.
8.
If required, use the optional [Page programming] function to insert pages and define the media
and finishing settings per page range.
9.
Touch [Ready] again to close the [Page programming] function.
10.
Press
.
Combining subsets into one document
242
Chapter 7 - Carry Out Copy Jobs
Canon varioPRINT 135 Series
To Next Page
Loading...
