Canon varioPRINT 110 - Define the Finishing for Print Jobs

Define the Finishing for Print Jobs
Introduction
The required finishing method is usually set in the printer driver. However, you can change the
finishing method on the control panel.
Depending on the configuration of your system you can change the following finishing methods,
for example.
• Number of staples.
• Number of punch holes.
• The location of the staples or punch holes.
• Folding method.
• Trimming method.
NOTE
You cannot change this setting for the active print job
.
Procedure
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or select a
DocBox.
2.
Touch the job you want to change.
3.
Touch [Properties], or double-tap the job to open the [Properties] window.
4.
Touch the [Binding], [Folding] or [Trimming] button.
5.
Make the required settings.
6.
Press [OK].
Define the Finishing for Print Jobs
172
Chapter 6 - Carry Out Print Jobs
Canon varioPRINT 135 Series