Canon varioPRINT 110 - Use Accounting; Select an Accounting Mode

Use Accounting
Select an Accounting Mode
Introduction
NOTE
Accounting requires a license. Contact your local authorized dealer for more information.
When the [Identification enabled] setting in the Settings Editor is set to [Yes], the accounting
function becomes available on the control panel. In the [Accounting mode] setting on the control
panel, you can select when an account ID must be entered. The table below describes the
options.
The accounting modes
Setting Description
[Per job] Each job requires an account ID. You can enter a new ac-
count ID for each job. By default, the control panel dis-
plays the account ID used for the previous job. However,
you can change the account ID displayed.
[Per job(Clear account ID)] Each job requires an account ID. You must enter a new
account ID for each job. The system clears the account
ID used for the previous job. Therefore, the [Account ID]
field in the [Job] pane is empty before the next job.
4
Use Accounting
344
Chapter 15 - Accounting
Canon varioPRINT 135 Series