Canon varioPRINT 110 - Page 180

Attribute Description
[Sort] You can indicate whether the jobs must be sorted [By Set] or [By
Page].
[Media] You can enter the media that must be used.
[Fit to media] You can indicate whether every page must be scaled to the media
size.
[Print sides] You can indicate whether the jobs must be printed one-sided or
two-sided.
[Orientation] You can indicate whether the prints must be [Portrait] or [Land-
scape].
[Rotate 180 degrees] You can indicate that the prints must be rotated 180 degrees.
[Tumble] You can indicate the orientation of page images on opposite sides
of a sheet.
When [Tumble] is set to [Yes], the two pages are oriented in such
a way that the binding is at the top or bottom. The image is rota-
ted 180 degrees on alternate pages. Both sides of the page are
printed. However, the position of the image is reversed (from top
to bottom) on every other page.
When [Tumble] is set to [No], the binding is at the left or right. The
images are not rotated on alternate pages.
NOTE
[Tumble] is only possible when the setting [Print sides]
is set to [2-sided].
[Impositioning] You can indicate how the prints must look, for example [2-up] or
[Same 2-up].
[Impositioning size] You can indicate the size of booklet jobs.
[Front or booklet cover] You can indicate which media must be used for the front covers or
booklet covers.
[Front cover print on] You can indicate which sides of the front cover must be printed.
[Back cover] You can indicate which media must be used for the back covers.
[Back cover print on] You can indicate which sides of the back cover must be printed.
[Perfect binding] You can indicate where the binding must be done, for example
[Left binding] or [Right binding]
[Offset stacking] You can indicate whether each next job or set must be stacked
with an offset compared to the previous job or set.
[Staples] You can indicate where the prints must be stapled, for example
[Top left] or [Top right].
[Output location] You can indicate where the jobs are sent, for example to the stack-
er.
[Sheet order] You can indicate the order in which the sheets will be delivered,
for example [Face down - Normal order].
[Feed edge] You can indicate whether the sheets will be fed [Long edge] or
[Short edge].
4
Introduction to Automated Workflows
Chapter 6 - Carry Out Print Jobs
179
Canon varioPRINT 135 Series