The Factory Default Templates
Overview of the templates
Template When to use
[Copy job] Copy originals that have the same media size and only require
simple settings, for example two-sided or a staple.
[Combined copy job] Combine several sets of originals with the same or mixed media
size, and create one single copy job.
When you select this template, the possibility to add subsets is al-
ready displayed.
[To DocBox]
NOTE
[To DocBox]is
only visible when
your system is
equipped with
the optional Doc-
Box function.
Send the job to the DocBox to get extended possibilities to pro-
grammed each page separately.
When you select this template, the destination of the copy job is
set to the first available DocBox. The destination is always set to
this DocBox, even when a different copy job destination has been
defined for the active workflow profile.
However, you can change the DocBox to which the job must be
sent.
[Booklet job] Create booklets from paper originals.
When you select this template:
• The [Layout] setting is set to [Booklet], and
• The [Media] setting is set to A3/Tabloid, because the system as-
sumes you want to create booklets of A4/LTR originals.
[Last used] Reuse the settings of the previous copy job for your new copy job.
NOTE
You cannot use [Last used] when the previous job was a
scan job or a combined copy job.
[Mixed size] Copy a set of originals that consists of different media sizes. The
output will also consist of these different media sizes.
Introduction to the Copy Function
Chapter 7 - Carry Out Copy Jobs
211
Canon varioPRINT 135 Series
To Next Page
