Power mode Control panel Description
Sleep mode Off Once the printer has been idle for the time defined in the
[Sleep mode timer] setting in the Settings Editor, the
printer goes into sleep mode automatically. Compared
to the low power mode, the printer uses less energy.
Possible values: 31 - 240 minutes.
Factory default: 40 minutes.
The printer wakes up when:
• You press the Sleep button
on the control panel, or
• A wake-up timer expires, or
• A job arrives in the list of [Scheduled jobs], provided
that the [Automatic wake-up enabled] setting in the
Settings Editor is set to [Yes].
Press the Sleep button on the right-hand side of the
control panel to put the printer into the sleep mode man-
ually. The printer goes into the sleep mode after all jobs
are finished.
When the [Deep sleep mode enabled] setting is set to
[Yes], the printer goes into the deep sleep mode.
Deep sleep mode
Off The deep sleep mode is an alternative to the sleep mode
described above. To use the deep sleep mode, the [Deep
sleep mode enabled] setting in the Settings Editor must
be set to [Yes].
In the deep sleep mode:
• The printer uses less energy than in sleep mode.
• The printer needs more time to wake up than in sleep
mode.
NOTE
An application in your workflow may require
the printer to wake up more quickly. If the
printer does not wake up quick enough, the
application may give an error. In that case it is
advised to disable the deep sleep mode. Then
the printer will use the sleep mode instead.
Power Buttons and Power Modes
Chapter 3 - Power Information
31
Canon varioPRINT 135 Series
To Next Page
Loading...
