Setting Description
[Start of run detection] You can indicate if the system checks for glue pollution before the
start of a run.
Select [On] if you want the system to check for glue pollution be-
fore the start of a run.
Possible values:
• [On]
• [Off]
Factory default value: [Off].
NOTE
It is advised that you enable [Start of run detection] only
when you often use recycled media.
Advised settings for different types of users
Setting Normal user User that demands high quality
Plain paper Frequent use of
recycled media
Plain paper Frequent use of
recycled media
[Automatic drum
cleaning]
[On] [On] [On] [On]
[Glue detection
interval]
[350 sides] [350 sides] [100 sides] [100 sides]
[Glue detection
sensitivity]
[Normal] [Normal] [Very high] [Very high]
[Resume auto-
matically after
cleaning]
[Yes] [Yes] [Yes] [Yes]
[Start of run de-
tection]
[Off] [On] [Off] [On]
How to Change the Settings for Automatic Drum Cleaning
Procedure
1.
On the control panel, touch [System] -> [Setup] -> [Advanced media settings] (under [Advanced]).
2.
Touch the [Automatic drum cleaning] button to enable the setting.
3.
If required, change the values of the settings described in the table.
4.
Touch [Apply] to confirm the changes.
Automatic Drum Cleaning
Chapter 17 - Cleaning
369
Canon varioPRINT 135 Series
To Next Page
Loading...
