EasyManuals Logo

Cardinal 201 User Manual

Cardinal 201
158 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
Model 201 Installation & Technical
8400-M117-O1 Rev D
Page 103
5.17 Test
tESt
With test displayed, press the F3/ key. The display will change to dSP=.
Proceed to the dSP= (Display Test) parameter.
dsp= (Display Test)
Press the F3/ key to show the current setting. If the setting displayed is
acceptable, press the F3/ key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/ key to save
it. Allowable settings are:
no
Display Test is Disabled
With no displayed, press the F3/ key. The display
will change to HirES. Refer to section
5.18 Display High Resolution Weight of this manual.
test
Run Display Test
1. All horizontal segments will turn on and then off.
2. All vertical segments and decimal points will turn
on and then off.
3. The status arrows will turn on and then off.
4. Each weight mode annunciator (lb, kg, etc.) will
turn on and then off.
5. The model number 201 will be displayed.
6. The display will change to HirES. Refer to
section 5.18 Display High Resolution Weight of
this manual.
reu
Show Display Revision
1. The display software version will be displayed.
2. The display will change to HirES. Refer to
section 5.18 Display High Resolution Weight of
the manual.

Show MAC Address
1. The MAC address will display as two screens such
as “00:50:C2” then “88:E0:0E”.
2. The display will change to HirES. Refer to
section 5.18 Display High Resolution Weight of
the manual.

Table of Contents

Other manuals for Cardinal 201

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cardinal 201 and is the answer not in the manual?

Cardinal 201 Specifications

General IconGeneral
BrandCardinal
Model201
CategoryTransmitter
LanguageEnglish