Cardinal 201 - 6 Weight Transmitter Setup Review; Accessing Setup Review

Model 201 Installation & Technical
8400-M117-O1 Rev D
Page 107
6. WEIGHT TRANSMITTER SETUP REVIEW
The Model 201 allows the metrological (Setup, Scale and Filter) parameters to be
reviewed without breaking the calibration seal. The prompts will follow the same
order as if the Calibration switch were pressed, but the values will be read only and
cannot be changed.
6.1 Accessing Setup Review
sEtup
1. With the weight transmitter ON, press the F1/ key and the
F2/ key simultaneously.
2. The display will change to show dAte (the prompt to set the
date and time).
3. Press the F2/ key until the display changes to show SETUP
(the prompt to view the setup parameters).
4. With Setup displayed, press the F3/  key.
5. To exit, press the F3/  key to step through the remaining
prompts OR at any time, cycle the power.
6. The weight transmitter will return to the normal weight display.