Cardinal 201 - Digital Input;Output

Model 201 Installation & Technical
8400-M117-O1 Rev D
Page 79
5.10 Digital Input/Output
digio
With digio displayed, press the F3/  key. The display will change to InP 1=.
Proceed to the InP 1= (Digital Input 1) parameter.
InP 1= (Digital Input 1)
Press the F3/  key to show the current setting. If the setting displayed is
acceptable, press the F3/  key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/  key to save
it. Allowable settings are:
Selection
Function
off
Off (Digital Input 1 is disabled)
2ero
Zero Scale
tare
Tare
gr-net
Gross/Net
Units
Units
print
Print
dfCSt
Digital Fill Control Start/Pause
dfCdC
Digital Fill Control Discharge