To Next Page

To Previous Page

Model 201 Installation & Technical

8400-M117-O1 Rev D

Page 34

4.7.1 Single Point Calibration

CAL1= – First Calibration Weight

1. The display will show CAL1=. This is the first of two

calibration weights. This weight could be ZERO (NO LOAD)

or the TEST WEIGHTS (TEST LOAD).

2. Press the F3/  key to view the current setting.

3. If the first calibration weight is to be ZERO (NO LOAD), press

the F3/  key.

4. If the first calibration weight is to be the TEST WEIGHTS

(TEST LOAD), use the F1/ and F2/ keys to input the

value of the test weights.

5. Place the weights on the scale platform, then press the F3/ 

key.

6. Starting at the left and proceeding right, a series of dashes

will appear on the display.

7. Next, starting at the left and proceeding right, the dashes will

disappear, after which the display will show: CAL2=.

CAL2= – Second Calibration Weight

1. The display will show CAL2=. This is the second of two

calibration weights. This weight could be ZERO (NO LOAD)

or the TEST WEIGHTS (TEST LOAD).

2. Press the F3/  key to view the current setting.

3. If the second calibration weight is to be ZERO (NO LOAD),

press the F3/  key.

4. If the second calibration weight is to be the TEST WEIGHTS