Model 201 Installation & Technical
8400-M117-O1 Rev D
5.11 Optional Memory Card
Store
With Store displayed, press the F3/ key. The display will change to Enabl=.
Proceed to the Enabl= (Enable Storage Card) parameter.
enaBl= (Enable Storage Card)
Press the F3/ key to show the current setting. If the setting displayed is
acceptable, press the F3/ key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/ key to save
it. Allowable settings are:
Off (Storage Card is Disabled)
ON (Storage Card is Enabled)
NOTE: If Store (Storage Card) is Enabled (on), the following
prompts, Log Messages to Storage, Days to Keep Log Messages
and Printer Output to Storage Card will be active.
Log= (Log Messages to Storage)
Press the F3/ key to show the current setting. If the setting displayed is
acceptable, press the F3/ key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/ key to save
it. Allowable settings are:
Off (Log Messages to Storage is disabled)
days= (Days to Keep Log Messages)
Press the F3/ key to show the current setting. To accept the setting
displayed, press the F3/ key again to save it. Otherwise, use the F2/
and F1/ keys to enter a new setting and then press the F3/ key to
save it. Allowable values for the number of days to keep log messages
are: 0 through 255.
To Next Page
Loading...
Need help?
General