Cardinal 201 - Connections; SPECIFICATIONS

Model 201 Installation & Technical
8400-M117-O1 Rev D
Page 1
1. SPECIFICATIONS
Power Requirements:
12-24 VDC @ 6w
Listed Accessory:
The weight transmitter is intended to be used with
Listed Information Technology Equipment.
Enclosure Rating:
IP-20 DIN Rail 35mm, mounted in customers’
enclosure with optional remote display mounting.
Enclosure Size:
4” W x 4.2” H x 1.9” D without connectors.
(101.6mm W x 106.7mm H x 48.3mm D)
Operating Environment:
Temperature: 14 to 104 ºF (-10 to +40 ºC)
Display Capacity:
Six digit, 7-segment, 0.5 inch high with Separate
annunciators, Over, Under and Accept backlight
indicators
Display Technology:
Transflective LCD with RGB LED backlight
Load Cell Excitation:
11.72 VDC
Signal Input Range:
0.5 mV min. to 35 mV max.
Load Cell Connection:
4 or 6 wire (remote excitation sensing)
Minimum Cell
Resistance:
43.75 ohms (8 – 350 ohm cells)
Division Value
Commercial:
Non-commercial:
1, 2, 5, 10, 20 or 50 x 10, 1, 0.1, 0.01, 0.001
0 to 99
Sensitivity:
0.5 uV / scale division
Resolution:
10,000 divisions
Sample Rate:
1 to 200 samples per second, selectable
Zero Range:
+/-2% to 100% full scale, selectable
Units of Measure:
Pounds, Ounces, Kilograms, Grams
Keys:
Six, membrane type
Serial Interface:
Bi-directional software selectable RS232
(30ft/10m up to 19.2k baud) OR
RS485 – 3,300ft/ 1000m, 24 AWG shielded &
twisted cable
USB:
5-pin mini USB device
Ethernet:
10/100 Ethernet (DHCP, TCP/IP, Embedded Web
Page, Modbus TCP, Ethernet IP)
Inputs:
4 Isolated inputs, 12-24 VDC current sink
Outputs:
4 Isolated outputs, 12-24 VDC current sink