Model 201 Installation & Technical
8400-M117-O1 Rev D
5.16 Print Tabs
tabs
With tabs displayed, press the F3/ key. The
display will change to dt l=. Proceed to the dt
l= (Date Line Print Location) parameter.
The general format for the input is L = (the
number of lines down) and C = (the
number of columns to the right).
dt l= (Date Line Print Location)
Press the F3/ key to show the current setting. To accept the setting
displayed, press the F3/ key again to save it. Otherwise, use the F2/
and F1/ keys to enter a new setting and then press the F3/ key to
save it. Allowable values are: 0 through 132.
dt C= (Date Column Print Location)
Press the F3/ key to show the current setting. To accept the setting
displayed, press the F3/ key again to save it. Otherwise, use the F2/
and F1/ keys to enter a new setting and then press the F3/ key to
save it. Allowable values are: 0 through 132.
t l= (Time Line Print Location)
Press the F3/ key to show the current setting. To accept the setting
displayed, press the F3/ key again to save it. Otherwise, use the F2/
and F1/ keys to enter a new setting and then press the F3/ key to
save it. Allowable values are: 0 through 132.
t C= (Time Column Print Location)
Press the F3/ key to show the current setting. To accept the setting
displayed, press the F3/ key again to save it. Otherwise, use the F2/
and F1/ keys to enter a new setting and then press the F3/ key to
save it. Allowable values are: 0 through 132.
To Next Page
Loading...
Need help?
General