Cardinal 201 - Accessing the Event Counters

Model 201 Installation & Technical
8400-M117-O1 Rev D
Page 120
10.1 Accessing the Event Counters
Etr
1. With the weight transmitter ON, press the F1/ key and the
F2/ key simultaneously.
2. The display will change to show dAte (the prompt to set the
date and time).
3. Press the F2/ key. The display will change to show ETr (the
prompt to view the event counters).
4. With Etr displayed, press the F3/  key. The display will
change to CFg= (the prompt to view the Configuration Counter).
5. Press the F3/  key to show the current value of the
configuration counter.
6. Press the F3/  key again. The display will change to CAL=
(the prompt to view the Calibration Counter).
7. Press the F3/  key to show the current value of the calibration
counter.
8. To exit press the F3/  key to step through the remaining
prompts OR at any time, cycle the power.
9. The weight transmitter will return to the normal weight display.