Model 201 Installation & Technical
8400-M117-O1 Rev D
4.8 Fine Span Adjustment
IMPORTANT! The F SPAn mode requires a load of 10% of
Capacity on the scale before adjustments can be made.
F span
Fine Span Adjustment (from SETUP Prompt)
1. With the SETUP prompt displayed, press the F2/ key until the display
shows the F SPAn prompt.
2. With F SPAn displayed, press the F3/ key.
3. The display will change to show FSPAN=, press the F3/ key.
4. The display will change to no. If you wish to skip fine span adjustment
and exit SETUP, press the F3/ key again.
5. Otherwise, place a calibrated test weight on the scale and press the
F2/ key to toggle to yes and then press the F3/ key.
6. The display will change to show the amount of the test weight, and an
F will be displayed to the right of the displayed weight.
7. Press the F2/ key to increase the span OR press the F1/ key to
decrease the span.
8. Press the F3/ key to exit the Fine Span Adjustment and return to the
normal operation mode.
Fine Span Adjustment (after completing calibration step, CAL2=)
1. With f span displayed, press the F3/ key.
2. The display will change to show FSPAN=, press the F3/ key.
3. The display will change to no. If you wish to skip fine span adjustment
and exit SETUP, press the F3/ key again.
4. Otherwise, place a calibrated test weight on the scale and press the
F2/ key to toggle to yes and then press the F3/ key.
5. The display will change to show the amount of the test weight, and an
F will be displayed to the right of the displayed weight.
6. Press the F2/ key to increase the span OR press the F1/ key to
decrease the span.
7. Press the F3/ key to exit the Fine Span Adjustment and return to the
normal operation mode.
To Next Page
Loading...
Need help?
General