Model 201 Installation & Technical
8400-M117-O1 Rev D
fast= (Fast Target)
This is the filling target that the 201 Admix is set to fill to.
NOTE: If the DFC Mode is set to “Off” this prompt is replaced with
the At Zero Delay (0-dEL on display). The At Zero Delay is how
many seconds that the 201 will wait upon going below the zero
threshold before setting the At Zero Output active.
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ and F1/ keys to enter a new setting
and then press the F3/ key to save it. Allowable values for Fast
Target are: 0 through scale capacity.
ptgt= (Pulse Target)
This is the amount of weight at which the 201 Admix system will
output a pulse on output 2 every change in weight of this amount.
For instance, if the Pulse Target is set to 1.0 (lb), then the 201
Admix controller will pulse output 2 every time the weight changes
1 lb (up or down).
NOTE: If the DFC Mode is set to DIO operation, this setting is
ignored as no pulse will be generated when in DIO mode.
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ and F1/ keys to enter a new setting
and then press the F3/ key to save it. Allowable values for
Pulse Target are from 0 (zero = off, no pulse generated) to
capacity of the scale.
To Next Page
Loading...
Need help?
General