Model 201 Installation & Technical
8400-M117-O1 Rev D
F1= (Function Key 1 Assignment)
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ key to toggle to a new setting and then
press the F3/ key to save it. Allowable settings are:
Units (key is used to toggle between weighing units)
Print (key is used to transmit data to output port)
Display Cycle (key is used to toggle between
weight, analog to digital voltage, time and date)
F2= (Function Key 2 Assignment)
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ key to toggle to a new setting and then
press the F3/ key to save it. Allowable settings are:
Units (key is used to toggle between weighing units)
Print (key is used to transmit data to output port)
Display Cycle (key is used to toggle between
weight, analog to digital voltage, time and date)
F3= (Function Key 3 Assignment)
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ key to toggle to a new setting and then
press the F3/ key to save it. Allowable settings are:
Units (key is used to toggle between weighing units)
Print (key is used to transmit data to output port)
Display Cycle (key is used to toggle between
weight, analog to digital voltage, time and date)
Display will return to weight mode when power is cycled.
To Next Page
Loading...